ZoneDirector

ZoneDirector

ZoneDirector

1.7K

  • •••
A
Issue Connection 2.4Ghz and 5Ghz can not stable

I have got issue within this below -2.4 dan 5 ghz enable some windows connect successful ( 802.1x authentication)-2.4 Ghz only some windows successfu

Question

4

0

0

will SNMP damage the zone director 1200/1205

Yep.. it sounds like a stupid question, but does R/O SNMP do anything to a zone director that is likely to make it fail? In particular, does it c

Question

2

0

0

ruckus 1200

Have a 1200 on the latest firmware 10.5.0.0 build 190. some clients are either: 1. loosing the pw for the wifi point 2. loosing the ip address o

Question

17

4

0

Ruckus ZD1200 Guest using external captive portal with Cisco ISE

Hi All ZD1200 ver 10.5.0.0 build 190  (ip:10.1.100.30) cisco ISE : 3.0.0.458 (ip:10.1.100.29) I want to use Cisco ISE captive portal for guest

Question

24

2

0

Adding TLS version support on vSZ-H

Hi all,   I have a vSZ-H controller and was recently asked question by a client regarding TLS versions. They want to switch off TLS v1.0. After

Question

7

1

0

ZF2942 Upgrade to 9.7.0.0.220 causes problems

Upgrading standalone 2942 AP from 9.6.1.0.15 to 9.7.0.0.220 makes only troubles for us. I have 2x 2942 standalone AP's. After upgrade both of them n

Question

 • 

Answered

16

10

Issue with 9.7 on ZF2942 on ZD controlled AP

Not to hijack, but I have a ZD3100 and 51 2942 APs...and upgraded to 9.7. Same symptom, connected clients became disconnected clients. Average 300

Question

9

3

ZD 1200 System settings and Event logs disappear

Dear all,        A few days ago, I configured  2xZD1200 system settings( name, IP addresses,mgmt interface,vlan, etc...)

Question

32

1

0

Upgrade firmware for ZA1200.

Hi everybody, I have a wireless controller ZD1200 model runnig 9.10.2.0.76 (MR3, Refresh 76) firmware version and APs T300 and R610 series, my questi

Question

30

3

0

ZD1200 dead?

Hi,I have a ZD1200 which controls around 8 APs setup, however this looks to have died.Looking at the controller, the power and status lights are solid

Question

 • 

Answered

204

3

Important Announcement

Announcements

Categories

View More