Wireless Questions & Best Practices

Wireless Questions & Best Practices

Wireless Questions & Best Practices

395

  • •••
F
Interference with T710

Hello Ruckus community I am working on installing a wifi network with the T710 and I am faced with the presence of another wifi network in the same area. is it possible for the AP T710 to avoid interference from other networks with the activation of the channelfly? if so, how is it done? I want to

Question

17

1

0

How to set up VLAN with new Ruckus hardware

Hi everyone, we just built a house and we have the following network components: Netgear R7800 router with OpenWRT Ruckus ICX7150-C12P switch 2x Ruckus R320 APs (one on each level) I am completely new to Ruckus, VLANs and OpenWRT. My target is to have two VLANs, one for IOT/HomeKit component

Question

138

4

Latency (5G)

We are troubleshooting lag issues with wireless at one of our sites. We use an Ekahau Sidekick with Rukus best practices for a site survey. The site survey site (using ruckus best practice looks great) except for lack of secondary signal in some areas In the controller (Smart Zone 100, ver 6.0

Question

15

1

0

Raspi won't connect to Unleashed 200.10.10.5.246 w/ 3 APs, WPA2/WPA3-Mixed

Dear all, a Raspberry Pi 4 / raspian won't connect to Unleashed 200.10.10.5.246 w/ 3 APs in WPA2/WPA3-Mixed mode. It works fine when changing to WPA2 mode. Not sure about the exact reason, does anyone have an idea? - Joachim. PS: If the resolution of the screenshot should be

Question

20

1

0

Symptom that wifi connection is repeatedly cut off only on Mac BOOK

sz-144 R750 configuration The phenomenon that the connection to the wlan is cut off occurs only in mac book Problem solved when using ssid clone May I know what is the cause?

Question

42

1

0

Large campus network: best practices for Airplay (+ issues with lots of Apple TV's)

We have a large campus network: ZoneDirector ZD1200, ± 50 AP's R500 and R510, ± 100 Apple TV's, lots of iPads (1:1 and shared iPads). The Apple TV's and iPads are on the same SSID, but in small VLAN's/subnets. The backbone of our network has high performance. WiFi speed and reliability are perfect.W

Question

 • 

Answered

1.6K

9

LoRa downlink control though vriot

Hi everyone,I can receive the FRMpayload uplink from the LoRa node through the websocket node by build-in node-red. But I want to send a payload downlink to control the LoRa node is not success.Any talents can help & give me an example? My platform is vriot v1.5.1.1.22 Thanks a lot! 

Question

12

0

0

Upgraded R710 to Unleashed firmware by mistake

I was looking to update my R710 but did not realize at the time that I had a SOLO ZoneFlex firmware revision and I downloaded the latest Unleashed firmware by mistake. I upgraded the WAP and did come back initially and it seemed to be working as people could connect to the WIFI. I tried to login to

Question

37

1

0

Setup Trouble

Hello, I am in a new Lennar home, which has two R510 devices. I am not tech-savvy. I followed the instructions on how to set up, but when I go to choose the configure.me network, all the Ruckus devices on the block are displayed. How do I know which one is mine? Also, do I have to configure each dev

Question

23

1

0

I have equipment but do not know how to set up

Hello, I need some help understanding and setting up a Smart Home. I have a lot of equipment for a pervious home. My Condo is 2 stories and 13 years old; it has COAX and CAT5E phone wires thought out the home, all the cabling start in the garage.  I have installed CAT5E connector to all the ph

Question

17

0

0

Important Announcement

Announcements

Categories

View More