Switches

Switches

Switches

526

  • •••

Accepted Solution

ICX 7750 Silent Fan Modul

Do they exist ? Or can someone recommend silent fans fitting in the psu ?

Question

25

2

0

ICX 7450

Version 8095A was installed on a new ICX7250. In the Web interface, there are no Mac-Address entries getting logged. Is there a command that should be done?  

Question

21

2

Accepted Solution

Optical monitoring not possible on ports with link down?

Am I missing something or the optical monitoring only works when the link is up? I am trying to troubleshoot some fiber connections which were unreliable / not coming up and when I use the `show optical-monitor x/y/z` command, I get nothing. Just comes back to the prompt. If the same port with the

Question

125

7

Accepted Solution

ver 08.0.70aT213 for ICX 7450 campus switches

Hi All, I'm having a difficult time locating this specific firmware rev that we're using in our environment: (ver 08.0.70aT213) We have some legacy deployments that use ICX 7450 switches where we wish to use this firmware until we are ready to roll them up. Is it possible to get a hold of this s

Question

25

2

0

RUCKUS ICX

Hi, everybody, i have a question about the RUCKUS ICX Stack.i have a new Stack with two switches and the sw show me three switches. The ID 3 ist show as a member and it is reserved. How can i delete this ID3

Question

28

1

0

ICX 7150 - dumb switch default password

I've installed a couple of Ruckus ICX 7150 switches with no configuration and I would like to configure them remotely but when I ssh in, it wants a password which I never set.  Suggestions?

Question

3.3K

6

ICX 6450 VLAN Help

Hey all, My network currently consists of a pfsense firewall, ubiquiti 8 port switch, and an R610 AP. I've been slowly moving away from ubiquiti products and picked up an icx 6450-48p switch to replace what I have. The issue I've been having, and it's 100% because of my lack of knowledge on how to

Question

129

1

0

ICX 6610 debug information

Hello, I have a ICX 6610 and when I did a show debug command, it always have that: Debug message destination: Consolevtable_sync debug enabled for all portsvtable_sync debug enabled for port INVALID Even if I do a undebug all, I have always vtable_sync debug.  What is that?  How remove

Question

16

1

0

Problem with ICX6610 SSH connexion

Hello, I have a ICX6610 configured with SSH. Everything works fine since last week.  Unable to connect with our account via Tacacs+ server.   Only the local account works.  All my others switches are OK and works fine.  So it's not the tacacs server.  And if I look int

Question

33

1

0

Important Announcement

Announcements

Categories

View More