ZoneFlex Mesh presetting

  • 1
  • Question
  • Updated 10 months ago
  • Answered
Hello everyone
There is a need to mount the access point without uplink.
The difficulty is that this access point can't be accepted, provisioned and configured by the controller before installation.
Is it possible to configure the access point not only the ip address of the controller, but the Mesh network to which it is necessary to connect when the power is turned on?

Thank you in advance for your cooperation

Regards,
Pavel
Photo of Pavel Semenischev

Pavel Semenischev

  • 15 Posts
  • 1 Reply Like

Posted 11 months ago

  • 1
Photo of Sean

Sean

  • 342 Posts
  • 87 Reply Likes
This can be accomplished by doing the following:

Enable mesh:
set mesh auto
For manual mesh provisioning, use meshprov
set meshprov {ssid|passphrase} "<value>"
For Mesh configuration recovery, use meshcfg
set meshcfg {ssid|passphrase} "<value>"
To set IP address
set ipaddr wan 192.168.0.2 255.255.255.0 192.168.0.1
If the network has a VLAN
set ipaddr wan vlan 10 192.168.0.2 255.255.255.0 192.168.0.1
Note: Ensure you set the ethernet interface to trunk or the VLAN will not work
set interface eth1 type vlan-trunk untag none
Good Luck :)
(Edited)
Photo of Michael Brado

Michael Brado, Official Rep

  • 1889 Posts
  • 269 Reply Likes
Find your ZD's Mesh ssid|passphrase info on the Configure/Mesh ZD WebUI page!
https://support.ruckuswireless.com/answers/000001491
(Edited)
Photo of Pavel Semenischev

Pavel Semenischev

  • 15 Posts
  • 1 Reply Like
Hi Michael,
I faced with a problem that AP T301 with FW:100.0.0.0.127 don't know mesh commands.
And I can't configure it.

Any ideas? 
Photo of Pavel Semenischev

Pavel Semenischev

  • 15 Posts
  • 1 Reply Like
Thanks guys
This is what we need