Why does ZD and SZ restrict downgrading in running status?

  • 1
  • Question
  • Updated 2 years ago
  • (Edited)
  • 1
Hi Dear.

Why does Ruckus block downgrading from ZD and SZ?

Especially, Why does ZD block downgrading to older version?

In ZD, if you would downgrading, must factory-set and re-configure from initial level.

Though you had done backup configuration, you don't resore new version(downgraded version) because the configuration didn't match f/w version.

I don't understand it.

Also ZD don't have cluster-backup/restore like SZ(exactly snapshot)

It's very inconvenient.

Do Ruckus have plan about flexible downgrading in further release?

Regards.
Photo of Jeronimo

Jeronimo

  • 302 Posts
  • 35 Reply Likes

Posted 2 years ago

  • 1
2 years ago
Photo of Martin

Martin, Official Rep

  • 307 Posts
  • 78 Reply Likes
Hi Jeronimo,

I think you gave the answer yourself already.
With a new version comes new features or database / config changes.
For that reason we push always the config backup on the ZD so you can roll back.
In that case use the upgrade function select the old firmware and after that upload the config backup of that version.

With SZ, we recommend to make a cluster backup, which is a full backup and you can restore to that also with the restore local command in CLI or via the webgui.

Kind regards
Martin
2016-10-27T07:31:19+00:00
Photo of Jeronimo

Jeronimo

  • 302 Posts
  • 35 Reply Likes
Hi.

In zd, After downgrading for older version, we cannot import previouly config backup file.

If we import the file, ZD issue msg as "....mismatch fw version...."

Thus if we need to downgrading, we must re-start configration from initial setup.

Regards.
Jeronimo
(Edited)
2 years ago
Photo of Martin

Martin, Official Rep

  • 307 Posts
  • 78 Reply Likes
Hi Jeronimo

Let me try to explain in more detail 

When you for example running version 9.8.3 on the ZD and you want to upgrade to 9.9 you are pushed before doing the upgrade the config backup for version 9.8.3. If you don't have that, you declined it before the upgrade.

So you should have the old config backup of your previous software installation.

Kind regards
Martin
  • 1

Powered by Get Satisfaction