What is the password for configure.me ssid after factory reset on R510?

  • 1
  • Question
  • Updated 1 week ago
  • Answered
I have an R510 that was originally Unleashed, then flashed to run on my Cloud WiFi network and have now removed the unit from the network.  I'd like to flash this back to Unleashed and have done a factory reset by holding the reset button for 10 seconds.  I now see the configure.meXXXXX SSID but it's asking for a network password to connect to that SSID.  Is there a default password?  I thought that there wouldn't be a password requirement at all.
Photo of Kai Cheung

Kai Cheung, Employee

  • 6 Posts
  • 1 Reply Like

Posted 1 week ago

  • 1
Photo of Michael Brado

Michael Brado, Official Rep

  • 2588 Posts
  • 353 Reply Likes
Hm, try resetting it again... but I'm not sure that your AP will have Unleashed after it connected to the Cloud, where it would get SmartZone image installed.
A true Unleashed AP advertising configure.me-xxyyzz should not require a password, and should allow browser access to "unleashed.ruckuswireless.com" URL.
Photo of Kai Cheung

Kai Cheung, Employee

  • 6 Posts
  • 1 Reply Like
Thanks, have tried resetting 3 times and the configure.me ssid is still requesting a pw.  I fear this R510 may now be a brick as I can't log into it to flash back to Unleashed.
Photo of Michael Brado

Michael Brado, Official Rep

  • 2577 Posts
  • 351 Reply Likes
If you connect with cables, can you ping 192.168.0.1 address?
Photo of Kai Cheung

Kai Cheung, Employee

  • 6 Posts
  • 1 Reply Like
I'll have to try that and report back.  thank you for the suggestion.
Photo of Vince

Vince, Employee

  • 1 Post
  • 1 Reply Like
Hi Kay,
You can connect to the AP SSID with the following credentials: SSID Configure.Me-xxxxxx and PSK Key: AP S/N.
Cheers


Photo of Kai Cheung

Kai Cheung, Employee

  • 6 Posts
  • 1 Reply Like
That worked,  Was able to upload latest R510 unleashed image and access admin panel.  thank you for your help!