Do you know if you can migrate an existing vSZ-H instance from 1 to 3 interfaces without affecting the cluster serial no?
How does a VAR re-rerun the setup wizard from the cliJulian Daniels, Employee
- 9 Posts
- 0 Reply Likes
Posted 8 months ago
- 34 Posts
- 9 Reply Likes
Hi Julian,
You need to do a factory reset. To reset to factory settings of the controller system, use the following command:
as written in the Command Reference Guide.
Julian Daniels, Employee
- 9 Posts
- 0 Reply Likes
use the ‘set-factory’ command in the CLI and rerun the setup wizard and add the additional interfaces in your VMware partition.
- Do not delete the instance in ESXi or
- Move the instance in VMWare/VSphere
Both of these tasks will generate a new cluster serial no.
- 34 Posts
- 9 Reply Likes
I used the set-factory command in the past on a vSZ-E node and turned it into a vSZ-H. The SN did not change. No changes on the VMware.
You should ask a SE and Support for advice.
You should ask a SE and Support for advice.
Related Categories
-
SmartZone and Virtual SmartZone
- 593 Conversations
- 323 Followers