vSZ-H migration to 3 x interfaces - cluster serial no.

  • 1
  • Question
  • Updated 3 weeks ago

Do you know if you can migrate an existing vSZ-H instance from 1 to 3 interfaces without affecting the cluster serial no?

How does a VAR re-rerun the setup wizard from the cli
Photo of Julian Daniels

Julian Daniels, Employee

  • 9 Posts
  • 0 Reply Likes

Posted 3 weeks ago

  • 1
Photo of alexf

alexf

  • 32 Posts
  • 5 Reply Likes

Hi Julian, 

You need to do a factory reset. To reset to factory settings of the controller system, use the following command:

ruckus# set-factory

as written in the Command Reference Guide. 
Photo of Julian Daniels

Julian Daniels, Employee

  • 9 Posts
  • 0 Reply Likes

use the ‘set-factory’ command in the CLI and rerun the setup wizard and add the additional interfaces in your VMware partition.

  • Do not delete the instance in ESXi or
  • Move the instance in VMWare/VSphere

Both of these tasks will generate a new cluster serial no.

Photo of alexf

alexf

  • 32 Posts
  • 5 Reply Likes
I used the set-factory command in the past on a vSZ-E node and turned it into a vSZ-H. The SN did not change. No changes on the VMware.

You should ask a SE and Support for advice.