Using MIBs to monitor connected clients

  • 1
  • Question
  • Updated 4 years ago
Hi,

We run 9.6.1.0 build 15 on our Zonedirector 1100 running 11 Ap's, we are using PRTG as our network monitoring kit and we want to be able to see the number of units that are currently connected to each AP, we have the most current MIB's from the website which is the sensor we should be using to be able to see the number of clients on each AP?

We have tried the following sesnors:
Radio stats max sta
radio stats num auth sta
radio stats num sta
wlan0/1 num sta

Thanks,
Julius
Photo of Julius Kisielius

Julius Kisielius

  • 30 Posts
  • 1 Reply Like

Posted 4 years ago

  • 1
Photo of Bill Burns

Bill Burns, AlphaDog

  • 203 Posts
  • 38 Reply Likes
Try this:
https://github.com/bot779/getruckus
I'm not aware offhand, of what SNMP OID tells you how many clients are connected but his code will display a list of mac addresses per AP.

-Bill
Photo of Keith - Pack Leader

Keith - Pack Leader

  • 860 Posts
  • 51 Reply Likes
This thread highlights some OIDs used by others...

https://forums.ruckuswireless.com/ruc...
Photo of Sudhakar Pydi

Sudhakar Pydi, Employee

  • 1 Post
  • 0 Reply Likes
You can try this.

You can get total number of clients on each AP by using below oid.
Use 9.7 mibs,
Mib file name: RUCKUS-ZD-WLAN-MIB
Oid: .1.3.6.1.4.1.25053.1.2.2.1.1.2.1.1.15

String: .iso.org.dod.internet.private.enterprises.ruckusRootMIB.ruckusObjects.ruckusZD.ruckusZDWLANModule.ruckusZDWLANMIB.ruckusZDWLANObjects.ruckusZDWLANAPInfo.ruckusZDWLANAPTable.ruckusZDWLANAPEntry.ruckusZDWLANAPNumSta
Photo of Bill Burns

Bill Burns, AlphaDog

  • 203 Posts
  • 38 Reply Likes
Oh... Sudhakar has a better answer than me.
Here's my answer anyway.

Checking some old SNMP notes...

You should try this:
> [email protected]:ruckus# snmpwalk -On -c $COMMUNITYSTRING -v2c -Pe -m "" $CONTROLLER-IP .1.3.6.1.4.1.25053.1.2.2.1.1.2.1.1.15
> [email protected]:ruckus# snmpwalk -On -c $COMMUNITYSTRING -v2c -Pe -m "" $CONTROLLER-IP .1.3.6.1.4.1.25053.1.2.2.1.1.2.1.1.16
> [email protected]:ruckus# snmpwalk -On -c $COMMUNITYSTRING -v2c -Pe -m "" $CONTROLLER-IP .1.3.6.1.4.1.25053.1.2.2.1.1.2.1.1.2

replace $COMMUNITYSTRING with "public" or whatever your community string is.
replace $CONTROLLER-IP with the IP address of your zonedirector.

Did that give you what you want?

My old SNMP notes can be found here:
https://forums.ruckuswireless.com/ruc...