Tunnelling selective dynamic VLANs to ZDs in a single WLAN

  • 1
  • Question
  • Updated 7 years ago
Anyone know if it's possible to tunnel some VLANs back to the ZD and bridge other VLAN's traffic to the local switching within a single 802.1X WLAN (via a RADIUS attribute maybe)? Or is the only option to turn tunnelling on or off per WLAN? As far as I can see tunnelling is either on or off for a WLAN and can't be decided per VLAN.
Photo of Jody Botham

Jody Botham

  • 1 Post
  • 0 Reply Likes

Posted 7 years ago

  • 1
Photo of Michael Brado

Michael Brado, Official Rep

  • 3298 Posts
  • 523 Reply Likes
The WLAN tunneling option is all or not at all, cannot be selectively tunneled or local switched.
Photo of Soporte Ruckus

Soporte Ruckus

  • 1 Post
  • 0 Reply Likes
someone knows if there are other brands that do this, that have this feature?
Photo of Bill Burns

Bill Burns, AlphaDog

  • 203 Posts
  • 42 Reply Likes
AFAIK, cisco tunnels all traffic back to their controller.

There's an HREAP feature (which has since been renamed to something else) That causes an AP to *not* tunnel *any* traffic.

Warning: HREAP also disables most features of the controller.
(I.E. dynamic VLAN assignment, etc. goes out the window)

I did not dig too deeply on this w/ Meru gear.
The reseller I dealt with was unable to answer such questions despite being a highly rated reseller and describing another customer situation where that capability would have been advantageous.