SWITCH Configuration

  • 1
  • Question
  • Updated 2 months ago
  • Answered
I am using CISCO SG300-10P POE model.
I want to know How to do DHCP SCOPE  on this model in CLI mode.
I just see steps in internet But it's not working on this particular switch.
So helpme to configure this.   
Photo of prabaharan B

prabaharan B

  • 3 Posts
  • 0 Reply Likes
  • confused

Posted 2 months ago

  • 1
Photo of Martin

Martin, Official Rep

  • 208 Posts
  • 46 Reply Likes
Hi Prabaharan,

For Cisco products please contact Cisco Support.

If you have any question on your Ruckus product we can assist you.

Kind regards
Martin
Photo of prabaharan B

prabaharan B

  • 3 Posts
  • 0 Reply Likes
ohh hoo!

thankyou martin :)
Photo of Michael Brado

Michael Brado, Official Rep

  • 2106 Posts
  • 297 Reply Likes
I had eleven years at Cisco, mostly in Tech Support and the SG300 was never popular in-house!
But if it has semi-IOS, you may be able to configure your DHCP with something similar to this old
example I've kept around... (and pulled out the option 43 that pointed an AP to a controller). 
It will reserve the low end for static IP assigned server/PCs on the wire, and assumes your ISP router
address is .254 in the scope.  You should be able to do something similar with your network range.
With best regards.

!
ip dhcp excluded-address 30.20.0.1 30.20.0.10
ip dhcp excluded-address 30.20.0.254
!
ip dhcp pool ap-pool
   network 30.20.0.0 255.255.0.0
   default-router 30.20.0.254
   dns-server 25.0.0.1
!
Photo of prabaharan B

prabaharan B

  • 3 Posts
  • 0 Reply Likes
 Thankyou   Michael 


But it's not working. I am a Beginner, Is this Right??
(Edited)
Photo of Michael Brado

Michael Brado, Official Rep

  • 2106 Posts
  • 297 Reply Likes
Nope, apparently the SG300 is not running regular/full IOS. Look for a Cisco manual on it I guess.