Smart Zone 100 startup wizard NTP server dialog box

  • 1
  • Question
  • Updated 3 months ago
If I assign the SZ a RFC1918 P address and do not allow it to access the WWW the initial configuration locks up.  If I leave the NTP server blank I cannot continue to the next step.  Is there a work around?
Photo of Joe Kelly

Joe Kelly

  • 8 Posts
  • 2 Reply Likes

Posted 3 months ago

  • 1
Photo of Shane Ferguson

Shane Ferguson

  • 13 Posts
  • 11 Reply Likes
Do you have an internal server that can provide NTP. Does you firewall http NTP server enabled?
at worst case use setup a temporary device to act as you NTP server and ensure that it has had its time set correctly.
Photo of Monnat Systems

Monnat Systems, AlphaDog

  • 923 Posts
  • 195 Reply Likes
i also ran into this and i put some LAN IP... which allowed me to complete the wizard...once i was in... i changed the NTP correctly..