I checked the command line but the only reference is in the ethernet port status:
ruckus# show ethinfo
System Ethernet Overview:
MAC Address= d4:00:00:00:00:00
Physical Link= up
MAC Address= d4:00:00:00:00:01
Physical Link= downSpeed= 1000Mbps
What i want to do is be able to bridge the second port in, so another device can connect to the network. So fairly simple. Note i have not connected the device yet. How do i set this?
However as an aside, i would have thought i could also configure the vlan options of each port, whether it is trunk/access mode, etc. Am i missing something?