Products: SmartZone and Virtual SmartZone
SCG200 list Data Plane physical ports
Updated 3 years ago
On the SCG is possible to see the status of the 2 logical Data plane interfaces.
Is it possible to see the 4 physical ports (DP0-0, DP0-1, DP1.0, DP1-1)?
Suppose that the DP1-0 fail, the DP1-1 became active, this failure raise any alarm on the SCG?
0 Reply Likes
Posted 3 years ago
3 years ago
, Official Rep
415 Reply Likes
I believe you will see an alarm on SCG.
I find some SNMP OIDs that appear to monitor Data Plane port up/down too.
I load one set of MIBs for SCG/vSZ-H, and one for SZ-100/vSZ-E, ie for SZ 3.2 and 3.1.2 respectively.
Find also the separate SNMP reference guides for each, with each release.
I can’t easily identify what OIDs might
represent SCG physical ports over vSZ-H, or how they’re
handled if related to physical port by
vSZ-H. But a ruckusSCGDPPhysInterfaceUp trap, points to a Data Plane
(physical or virtual?) as one
possibility that I see. And there’s an opposite ruckusSCGDPPhysInterfaceDown trap
for the other state of DP.
Maybe also ruckusSCGNodePhyInterfaceUp and ruckusSCGNodePhyInterfaceDown traps
my first glace thru an SCG/vSZ-H SNMP Ref guide.
person likes this
SmartZone and Virtual SmartZone
Powered by Get Satisfaction