SCG200 list Data Plane physical ports

  • 1
  • Question
  • Updated 1 year ago
  • Answered
On the SCG is possible to see the status of the 2 logical Data plane interfaces.
Is it possible to see the 4 physical ports (DP0-0, DP0-1, DP1.0, DP1-1)?

Suppose that the DP1-0 fail, the DP1-1 became active, this failure raise any alarm on the SCG?
Photo of Rui Carvalho

Rui Carvalho

  • 1 Post
  • 0 Reply Likes

Posted 1 year ago

  • 1
Photo of Michael Brado

Michael Brado, Official Rep

  • 2116 Posts
  • 297 Reply Likes
I believe you will see an alarm on SCG.

I find some SNMP OIDs that appear to monitor Data Plane port up/down too.

I load one set of MIBs for SCG/vSZ-H, and one for SZ-100/vSZ-E, ie for SZ 3.2 and 3.1.2 respectively.



 

https://support.ruckuswireless.com/software/853-smartzone-3-2-ga-mibs-for-scg-and-vsz-h-zip


https://support.ruckuswireless.com/software/866-smartzone-3-1-2-mr-mibs-for-scg-and-vsz-h-zip


 

https://support.ruckuswireless.com/software/934-smartzone-3-2-ga-mibs-for-sz-100-and-vsz-e-zip


https://support.ruckuswireless.com/software/871-smartzone-3-1-2-mr-mibs-for-sz-100-and-vsz-e-zip


Find also the separate SNMP reference guides for each, with each release.

 

https://support.ruckuswireless.com/documents/875-smartzone-3-2-ga-snmp-mib-reference-guide-scg-200-vsz-h


https://support.ruckuswireless.com/documents/924-smartzone-3-1-2-snmp-mib-reference-guide-scg-200-vsz-h


 

https://support.ruckuswireless.com/documents/901-smartzone-3-2-ga-snmp-mib-reference-guide-sz-100-vsz-e


https://support.ruckuswireless.com/documents/968-smartzone-3-2-1-mr-snmp-mib-reference-guide-sz-100-vsz-e


 

   I can’t easily identify what OIDs might
represent SCG physical ports over vSZ-H, or how they’re


handled if related to physical port by
vSZ-H.  But a ruckusSCGDPPhysInterfaceUp trap, points to a Data Plane


(physical or virtual?) as one
possibility that I see. And there’s an opposite ruckusSCGDPPhysInterfaceDown trap


for the other state of DP. 



     Maybe also ruckusSCGNodePhyInterfaceUp and ruckusSCGNodePhyInterfaceDown traps
apply

too?   That’s
my first glace thru an SCG/vSZ-H SNMP Ref guide.