i installed the Unleashed FW on two R500 APs.
I configured the first AP and everythink looks fine. Very Nice!
After that i connected my second R500 Unleashed AP with my local Network. The AP is not discovered or listed within my Unleashed GUI. AP got an IP from my DHCP. From my Master i am able to ping the other AP. If i try to connect to this IP via Browser the Unleashed Setup Wizard appears. "Auto approve" is enabled on my Unleashed Master.
Please try a factory default (indented pin by Eth ports for 8 sec) and let it boot
up again. From your initial Unleashed AP, APs page, does the second AP appear
at all (possibly in red)? Can you click AP details and see the firmware version?
Does the new APs version match your first Unleashed AP?
If your LAN has Internet connectivity, APs should be auto-upgraded when they
check with the AP registrar. Version 220.127.116.11.608 is the official GA release that you
need on both APs. Please let us know your status.
Are their any other paths to adding AP's that relying on the autoconfiguration from the master?