Ruckus R500 can't detect at SZ100

  • 1
  • Question
  • Updated 9 months ago
  • Acknowledged
R500 using solo firmware 104.x.x, AP able to ssh and set scg, SZ100 is using firmware version 3.6.x.x , only a few AP start with mac-address d4:68:4d:xx:xx:xx can't connect, others AP with different mac-address can connect.

Photo of Mohamad Abu

Mohamad Abu

  • 2 Posts
  • 0 Reply Likes

Posted 9 months ago

  • 1
Photo of chidung nguyen

chidung nguyen

  • 12 Posts
  • 2 Reply Likes
can you try :
#set director ip x.x.x.x(ip SZ100)
Hope helpful!
Photo of Syamantak Omer

Syamantak Omer, Official Rep

  • 500 Posts
  • 162 Reply Likes
Hi Mohamad,

Please SSH into the AP and check if you are able to ping the controller IP address.

Also set the controller IP manually on APs and also make sure that port 443 and 22 are not blocked between AP to controller network path.

set scg ip

Also try to login into the controller CLI and disable the AP cert check and see if it helps.

no ap-cert-check
Photo of Mohamad Abu

Mohamad Abu

  • 2 Posts
  • 0 Reply Likes
Hi Syamantak Omer,

thanks for helping, #config  #no ap-cert-check #end only this I haven't try yet.