R720 Unleashed fast flashing CTL LED

  • 1
  • Question
  • Updated 2 weeks ago
I am running newest Unleashed firmware. Was trying to do a factory reset but lost power before procedure can complete. Now I can't access GUI via 192.168.0.1 and CTL flashes fast. Can this unit be recovered?

Thanks.
Photo of cvccsi

cvccsi

  • 7 Posts
  • 0 Reply Likes

Posted 2 weeks ago

  • 1
Photo of Tony Heung

Tony Heung, Official Rep

  • 52 Posts
  • 14 Reply Likes
Best option is to open a support case with our technical team who can provide further assistance on the hardware reset and verify the flash status.
Photo of Syamantak Omer

Syamantak Omer, Official Rep

  • 473 Posts
  • 155 Reply Likes
Hi There.

Try doing a factory reset by pushing and holding reset button for 12 seconds. Once done, try to access default IP or DHCP assigned IP.

If still not working then open a case and they will verify.

Regards,
Syamantak Omer
Photo of cvccsi

cvccsi

  • 7 Posts
  • 0 Reply Likes
Thanks, got it working now.

I have ran into another issue. I am using AC power supply (740-64277-001/ 48V .75A). In GUI, I got a warning stating "not enough electricity power provided". Do I need to configure the AP to recognize its getting AC power source?

Thanks again.
Photo of Syamantak Omer

Syamantak Omer, Official Rep

  • 443 Posts
  • 141 Reply Likes
Not required.

Wait for sometime, error should disappear automatically.´╗┐

If not, then you may have to check.

Regards,
Syamantak 
Photo of Syamantak Omer

Syamantak Omer, Official Rep

  • 443 Posts
  • 141 Reply Likes
Below is the recommended power supply and power specification for R720.



Regards,
Syamantak Omer
Photo of cvccsi

cvccsi

  • 7 Posts
  • 0 Reply Likes
That's the power supply I got. I have two of them and both behaves the same. It has been a day since I installed it and saw this warning. I'll give some more time then. What should I check for if problem persists? Thanks.
Photo of Syamantak Omer

Syamantak Omer, Official Rep

  • 443 Posts
  • 141 Reply Likes
Could you start a new thread for this query/issue, to keep different issue discussed under different threads.

Thanks!

Regards,
Syamantak Omer