R710 and switch

  • 1
  • Question
  • Updated 2 months ago
  • Acknowledged
i have set a vlan : vlan100 192.168.33.0
but my switch doesnt have vlan setup . How can i setup the guest wifi to get the 192.168.33.0 ip.
Thanks
Photo of lo lo

lo lo

  • 2 Posts
  • 0 Reply Likes

Posted 2 months ago

  • 1
Photo of Michael Brado

Michael Brado, Official Rep

  • 2521 Posts
  • 346 Reply Likes
Connect your Router with the 192.168.33.x interface.
Photo of lo lo

lo lo

  • 2 Posts
  • 0 Reply Likes
but i want to have two SSID NETWORK:
192.168.33.x guest wifi
192.168.55.x main wifi
Photo of Michael Brado

Michael Brado, Official Rep

  • 2518 Posts
  • 345 Reply Likes
Your L2 switch only supports one subnet/vlan.  Your R710 has 2 Ethernet ports.  

If you run Solo AP firmware, you can define Local Networks with 192.168.33.0/24 and 192.168.55.0/24
and assign them to Eth1 and Eth2 respectively.

You could then have 2 SSID, one for 33 subnet and one for 55 subnet.

But you could only attach "many" devices thru your current switch, on one R710 Eth port.

You would need another switch, or would be limited to one other device on the other subnet/Eth port.

It could do that, with just an R710 and a switch.  (No Internet of course without a Router/WAN link)