R300 cannot connect to vSCG

  • 1
  • Question
  • Updated 2 years ago
  • Answered
We have a problem to connect R300 with the vSCG. In configuration APs menus, we've got information that the provision stage is "Waiting for Registration."
In the event log, we've got the message that "R300 is not being upgraded with vSCG Enterprise AP Firmware because of ACL setting." Anyone facing the same problem ? Please share, what is the solution of this connection problem ? We are using the firmware version 100.1.0.0.194 for the R300 and vSCG 3.3.3.628. Thanks a lot..
Photo of Emanuel Andhy

Emanuel Andhy

  • 2 Posts
  • 0 Reply Likes

Posted 3 years ago

  • 1
Photo of Munish Dhiman

Munish Dhiman, Employee

  • 100 Posts
  • 14 Reply Likes
Hi Emanuel,

Login to the vSCG cli and use the floowing commands.


# configure
# lwapp2scg
# policy accept-all
#exit

Also Check all ACLs and open ports (mentioned in the configuration guide ) are verified.Also be aware of the Management Interface ACL selection .

Let me know 

Thanks 
Munish 
Photo of Paddy Naughton

Paddy Naughton

  • 9 Posts
  • 0 Reply Likes

Hi Emanuel,

We had the same problem here. By changing  the policy as stated above seemed to solve the problem. You still have to SSH into the AP and set the director to the IP address of your vSCG. It seemed to work intermittently from then on. Let me know how you get on.

Photo of Emanuel Andhy

Emanuel Andhy

  • 2 Posts
  • 0 Reply Likes
Thank You Munish & Paddy, problem was solved by installing the firmware 2.6, then do what Munish recommend &  set the Auto provisioning : enabled, SCG Agent : enabled.
After set the IP address to vSCG, then voila!!.. the R300 connected to the vSCG, install the bootstrap and upgraded the firmware to 3.0.3.. It works well now.
Thanks for your advice guys..

E. Andhy
Photo of Munish Dhiman

Munish Dhiman, Employee

  • 100 Posts
  • 14 Reply Likes
Thanks Emanuel . Happy to help !
Photo of jeff lin

jeff lin

  • 1 Post
  • 0 Reply Likes
Hi Munish:
Can vSCG manage R300 if R300 AP use firmware standalone 100.1.0.0.194 version?
If this version can't be managed,please kindly let me know the lastest can be managed version and where can download it?
Thanks.
Photo of Monnat Systems

Monnat Systems, AlphaDog

  • 776 Posts
  • 163 Reply Likes
Jeff,

Ideally any AP connecting to Vscg must run same firmware as Vscg. Once its running that firmware then point it to Vscg IP via CLI command. If firmware is correct, command and VSCG IP is correct, AP is able to go to the internet and Vscg has allowed this AP to join

then you should find this AP, joining and connecting to the internet...