Plugging other ethernet devices into the back of new APs

  • 1
  • Question
  • Updated 5 years ago
I just installed a new R700 AP. The location I installed it at I used the port from an existing printer which I then plugged into the back of the new AP. From there the printer stopped working despite having a green ethernet connection light next to the printer impute cable. I think the problem is that the AP is not allowing traffic through the port the cable is plugged into. Is there a good way to enable this function? I read the

documenting but found no solution. 

Photo of BC


  • 1 Post
  • 0 Reply Likes

Posted 5 years ago

  • 1
Photo of Monnat Systems

Monnat Systems, AlphaDog

  • 923 Posts
  • 208 Reply Likes
try this post, this shall fix your issue...
Photo of John D

John D, AlphaDog

  • 599 Posts
  • 188 Reply Likes
In addition to what Monnat Systems suggested, do you have any sort of VLAN configuration?