New Construction - Need Wifi Enabled

  • 1
  • Question
  • Updated 3 months ago
We are buying a new construction house.  It will be 2 floors with a basement.  We'll likely only have a cable modem supplying the data.  The modem will likely be on the made or 2nd floor.  What would be the preferred setup to ensure all floors have full connectivity?   

Also I'd like to enable rogue device detection as I want to ensure only devices I know about connnect to our Wifi.  Though this is less of a priority.

 Any suggestions would be appreciated.
Photo of David Fry

David Fry

  • 3 Posts
  • 0 Reply Likes

Posted 5 months ago

  • 1
Photo of Monnat Systems

Monnat Systems, AlphaDog

  • 923 Posts
  • 195 Reply Likes
david...
since your premises in under_construction. you have Cat6 cable dropped at relevant location on each floor...
use unleashed AP for wifi purpose.
If dropping cable drop is not a possible now then again you can go with Unleashed AP's (R500/R510, R600/R610 and so on) with mesh feature to have better and consistent connectivity.
unleashed is cost effective and shall meet your smart home needs including rogue device detection :)
Photo of David Fry

David Fry

  • 3 Posts
  • 0 Reply Likes
So one unit per floor? Connected via cat6. Can each of these APs have the same ssid?
(Edited)
Photo of Monnat Systems

Monnat Systems, AlphaDog

  • 923 Posts
  • 195 Reply Likes
ideally yes however it depends on floor size and type of construction material used/thickness etc. Cat6 yes
Yes - unleashed software allows you to have controller functions without investing in physical controller. Yes you can have all AP's broadcasting same SSID with unleashed.
Photo of Monnat Systems

Monnat Systems, AlphaDog

  • 923 Posts
  • 195 Reply Likes
btw.. if you have the scope of putting Cat6 in every floor then you can also consider unleashed AP model R310... its very cost effective however little less feature set & lesser range than R500/R510 & R600/R610 and so on.
if your requirement is just what you have mentioned above then R310 will fit the bill... Thx
Photo of jack

jack

  • 2 Posts
  • 0 Reply Likes
I would suggest that  there must be the other wifi setting should be helpful for more details visit Asus Router Customer Service
Photo of David Fry

David Fry

  • 3 Posts
  • 0 Reply Likes
Ok so I'm having low voltage cable run to both the center landing of my 1st and 2nd floor, this is central to all the living spaces.  (I will have to run to the basement later when I finish it).   My end goal is high performing wi-fi so that anywhere in the house connection is good and bandwidth does not degrade. 

We will not have more than 10 or so devices connected at any one time so it's not a high noise environment but there will be some noise.   

Cable with be either CAT5e or CAT6, not sure yet what this vendor uses.  

What would be the preferred device? Ruckus r500, r510, r600, r610?  I'm still trying to understand the differences between the base and the 10 models.    The cost isn't a major factor, I'm prepared to spend around 500 for each AP.   Cabling will all be terminated at a panel in the basement where I will be bringing in our cable modem.    

Wifi isn't my best area, I am a novice, so any suggestions would be appreciated.