Management of Ethernet ports of an H510 when in unleashed mode

  • 1
  • Question
  • Updated 3 months ago
When an H510 is running in unleashed mode and acting as master, there seem to be no options in the configuration interface to configure its 4 Ethernet ports.
I am afraid this is just unsupported as of release 200.3.9.13.228, but cannot find any evidence in favor of or against this conclusion.
Photo of Massimo Rimondini

Massimo Rimondini

  • 2 Posts
  • 0 Reply Likes

Posted 3 months ago

  • 1
Photo of Nat Chidambaram

Nat Chidambaram

  • 60 Posts
  • 22 Reply Likes
It is correct that those Ethernet ports are not configurable. Are you looking to put these ports in a specific VLAN or enable different authentication method? 
Photo of Massimo Rimondini

Massimo Rimondini

  • 2 Posts
  • 0 Reply Likes
Thank you. Yes, I would have liked to be able to enable/disable each port, set it up as a trunk/access/routed port, and set the access VLAN. Configuration of the authentication method is not a priority at the moment.
What seemed strange to me is that, besides the case of being managed by a controller, even in standalone mode the H510 provides a web interface to configure the ports under consideration.