LACP with R610

  • 1
  • Question
  • Updated 2 months ago
Hi, in the wireless network are 2 R610 and 8 R600, and i need to know if is possible configure LACP on R610 through of two ethernet ports? or what is the purpose of two interface ethernet?

Photo of Salvador Gallo

Salvador Gallo

  • 3 Posts
  • 0 Reply Likes

Posted 2 months ago

  • 1
Photo of abi

abi

  • 30 Posts
  • 8 Reply Likes
Hi Salvador,

In R610 you can use LACP and combine two gigports.

Regards,
Abilash PR.
Photo of Salvador Gallo

Salvador Gallo

  • 3 Posts
  • 0 Reply Likes
Hi Abi,


i has been research about of procedure. i found this instructions for CLI

##
To configure the AP for link aggregation:
    1. Verify that the AP power mode is 802.3at:
content_copy zoom_out_map
rkscli: get power-mode
PoE Configured Mode      : Auto
Power Consumption Status : 802.3at PoE+
OK
    2. Create the bond0 profile for the LAG group and add the two physical Ethernet interfaces to the LAG.
content_copy zoom_out_map
rkscli: set bond bond0 add eth0
rkscli: set bond bond0 add eth1

When you create the LAG group, LACP is automatically enabled.
    3. (Optional) Set the transmit hashing option to Layer 3 and Layer 4 to optimize hashing for common enterprise WLAN environments.
content_copy zoom_out_map
rkscli: set bond bond0 xmit-hash 1
###

this is corrrect?

Photo of abi

abi

  • 30 Posts
  • 8 Reply Likes
Hi Salvador,

Yes, that should be it.

Regards,
Abilash PR.