Jumbo frame support

  • 1
  • Question
  • Updated 3 months ago
I'm trying to figure out how to have different MTU's defined on a 7150 or 6450 switch.

I've read that I have to enable Jumbo frames on the general configuration label and then restart the switch to enable the support.

It appears that the MTU should be configurable per interface, however, the ip mtu commands seem to be missing when in an interface (e.g. eth 1/1/1) on a 7150.

I'm guessing I'm missing something...
Photo of Scott Farrand

Scott Farrand

  • 9 Posts
  • 3 Reply Likes

Posted 3 months ago

  • 1
Photo of Scott Farrand

Scott Farrand

  • 9 Posts
  • 3 Reply Likes
Apparently the interface IP MTU is only available on the routing image.