Important: Do NOT upgrade to SmartZone 5.2.0.0.685 if you have not.

  • 2
  • Announcement
  • Updated 5 months ago
  • (Edited)
Hello,

     A previously unseen issue with APs not being responsive following a reboot after being upgraded
to SmartZone 5.2.0.0.685 has led to our pulling the firmware downloads from the Support portal for now.

     We will resolve the issue, and re-post this important release, but please do NOT upgrade if you have
not done so yet (people who have downloaded SZ/vSZ 5.2.0.0.685).

     We have documented the issue in a Technical Support Bulletin (TSB-2020-002) referenced in a new
KBA-10114: https://support.ruckuswireless.com/articles/000010114
Photo of Michael Brado

Michael Brado, Official Rep

  • 3289 Posts
  • 521 Reply Likes

Posted 5 months ago

  • 2
Photo of David Black

David Black

  • 99 Posts
  • 52 Reply Likes
The TSB is on the support site but the pdf that's attached is corrupted. 
https://support.ruckuswireless.com/articles/000010114

Which AP models are affected?  How did something this flawed make it out the door?
(Edited)
Photo of David Black

David Black

  • 99 Posts
  • 52 Reply Likes
The corrupted pdf on the TSB has been fixed, but it contains nothing useful.
(Edited)
Photo of John D

John D, AlphaDog

  • 579 Posts
  • 179 Reply Likes
Also for affected models, what is recommended in the meantime? Downgrade to a different release ?
Photo of David Black

David Black

  • 99 Posts
  • 52 Reply Likes
According to the TSB the affected APs are bricked and RMA is required. Unbelievable...
Photo of Jeronimo

Jeronimo

  • 380 Posts
  • 48 Reply Likes
If we were allready done a upgrading, what is next action we should
Photo of Michael Brado

Michael Brado, Official Rep

  • 3289 Posts
  • 521 Reply Likes
Greetings,

    Issues were sorted out and SZ 5.2.0.0.699 has been posted to replace SZ 5.2.0.0.685.  Please
see the Technical Service Bulletin, and new Release Notes / Upgrade Guide, and follow the below
recommendations.

1.  If you have not upgraded to SZ 5.2 (b685), upgrade to SZ 5.2 (b699) instead.

2.  If you have upgraded to SZ 5.2 (b685) and do not have bricked APs, upgrade to SZ 5.2 (b699)

and also upgrade APs from (b1392) to (b1412) that is incorporated in SZ 5.2 (b699).

3.  If you have upgraded to SZ 5.2 (b685) and have bricked APs, RMA is the only recourse.  Please

upgrade to SZ 5.2 (b699) and migrate non-affected APs.





Photo of Heiko

Heiko

  • 2 Posts
  • 0 Reply Likes
Greetings,
where do we find the 5.2.0.0.699 for SZ100?
Cheers
Photo of Ankush

Ankush, Employee

  • 87 Posts
  • 52 Reply Likes
Hi Heiko,

Thank you for pointing out, we are getting it updated.

Regards,
-Ankush