i have ZoneDirector 1100 and now have ZoneDirector 3000 but i can't alow AP from ZoneDirector 1100 to ZoneDirector 3000?

  • 1
  • Question
  • Updated 2 years ago
Photo of salah bourgheid

salah bourgheid

  • 2 Posts
  • 0 Reply Likes

Posted 2 years ago

  • 1
Photo of Ahamed A

Ahamed A

  • 10 Posts
  • 0 Reply Likes
Hello Salah,

Please mention the firmware version of ZD 1100 and ZD 3000 running.

Are you trying to migrate all the APs from ZD 1100 to ZD3000 or only few APs like load balancing between ZD 1100 and ZD 3000?

Regards,
Ahamed.
Photo of salah bourgheid

salah bourgheid

  • 2 Posts
  • 0 Reply Likes
hi Ahamed

yea all APs, both ZoneDirector is running but ZoneDirector 3000 can't see APs in ZoneDirector 1100
Photo of Ahamed A

Ahamed A

  • 10 Posts
  • 0 Reply Likes
Hi Salah, 

Please let us know the firmware version running on both the controllers and what are the model number of the APs which are showing connected in the ZD1100?

Regards,
Ahamed.
Photo of Sean

Sean

  • 346 Posts
  • 88 Reply Likes
There are a couple of you things you need to do:

1. Make sure both ZD's have the same firmware to limit downtime.
2. Set up your Access Point Policies as below on both ZD's:



Once you have done this all AP's should migrate to the primary ZD.

You then just need to remove the Secondary ZD IP Address and your done.

Good Luck
(Edited)