I cannot pair 2 ZoneFlex P300 Wireless Bridge,

  • 1
  • Question
  • Updated 11 months ago
I cannot pair 2 ZoneFlex P300 Wireless Bridge, have completed all the config but the wireless status on the non-root bridge says the wireless is disabled
Photo of Alipate Ikanivoka

Alipate Ikanivoka

  • 1 Post
  • 0 Reply Likes

Posted 11 months ago

  • 1
Photo of David Saez

David Saez, Employee

  • 30 Posts
  • 6 Reply Likes
Hi Alipate,
- could you please verify all LEDs are Green and power is ON? 
- Also check you have same SSID and passphrase on both units.
- what is the range between both links? what type of antennas do they have?
- Please, go to Status --> Wireless , and in Site Survey side click on "ReScan". Do this on the Root Bridge (RB) and in the Non Root Bridge (NRB).
- After checking all the above, connect to CLI and give us the output of this command, for RB and NRB,
get scanresults wifi1
get mesh


Photo of Sanjay Kumar

Sanjay Kumar, Employee

  • 259 Posts
  • 83 Reply Likes
Hi Alipate,

If the above steps are followed and still have the issue, try setting the Root as Gateway on the Non root and check. I had this issue in lab setup and working on Gateway worked for me.

Sanjay Kumar