How to Re-flash an Unleashed AP back to standalone or ZD firmware

  • 1
  • Question
  • Updated 2 months ago
  • Answered
Hi. I flashed a T300 to use the Unleashed firmware and now I  would to convert this back to the original firmware but cant see an option within the unleashed GUI to do this. Is this possible?
Photo of simantsg

simantsg

  • 9 Posts
  • 0 Reply Likes

Posted 3 years ago

  • 1
Photo of The Blue Parrot

The Blue Parrot

  • 15 Posts
  • 3 Reply Likes
Yes, this is possible. First you have to set it to factory default settings. Second in the Setup Wizard after connecting to the configure.me SSID in the wizard is an option for show ap info -> choose Upgrade, there you choose the standalone image, flash the device and reboot -> Done
Photo of Michael Brado

Michael Brado, Official Rep

  • 2694 Posts
  • 373 Reply Likes
Documented in KBA-5193: Can I convert an Unleashed AP to ZoneFlex Standalone/Controller managed mode?
https://support.ruckuswireless.com/answers/000005193
Photo of Stephen Hall

Stephen Hall

  • 27 Posts
  • 1 Reply Like
hi,  this KB needs to be updated.  this option is no longer visable in any of the setup steps of unleashed 206.x
Photo of Michael Reed

Michael Reed

  • 2 Posts
  • 0 Reply Likes
i dont see a show AP info option at all 

Photo of Scot Hetzel

Scot Hetzel

  • 2 Posts
  • 0 Reply Likes
I was able to upgrade the firmware on a T300 AP that was running 206.x.  But first I had to downgrade to 204.x.  Then followed the instructions in KBA-5193.
Photo of Scot Hetzel

Scot Hetzel

  • 2 Posts
  • 0 Reply Likes
Originally, I was trying 9.8.1 on 206.x, if I had tried 110.x it might have succeeded.  As I found out later that the flash chip on the AP was a newer version and wasn't supported by the 9.8.1 firmware.
Photo of Alexey

Alexey

  • 44 Posts
  • 8 Reply Likes
I had did it with T300 by load T300_104.0.0.0.1347.bl7 on them (became Solo AP) and then upgrade them with ZD compatible SW.
U d be careful whith AP&Software compliance: some SWversions do not suits for ZD.
Photo of David Black

David Black

  • 24 Posts
  • 6 Reply Likes
Converting Unleashed to Zone Flex was straightforward when the interface was like the KB posted by Michael.  For several release now that option has been removed.  You have to go through the unleashed setup wizard, wait for the AP to build the unleashed network, login, go to administer/upgrade - and then finally you can upgrade to the model specific base 104 image, or if you're willing to put up with bugs, upgrade to the latest base 110.   
(Edited)