How to enable 11ax mode in R730?

  • 1
  • Question
  • Updated 4 months ago
  • Acknowledged
Enabling 11ax mode shows "parameter error when setting mode to 11ax" in   ZoneFlex Solo Access Point 108.2.0.0.837 (GA) Software Release (R730) 108.2.0.0.837, R730 AP.

Photo of Sathish Kumar KS

Sathish Kumar KS

  • 6 Posts
  • 0 Reply Likes

Posted 5 months ago

  • 1
Photo of Michael Brado

Michael Brado, Official Rep

  • 2916 Posts
  • 405 Reply Likes
Not sure, but do you have 802.3at PoE powering the AP?
Photo of Sathish Kumar KS

Sathish Kumar KS

  • 6 Posts
  • 0 Reply Likes
Yes we are powering on using POE. 
Photo of Brian Powers

Brian Powers

  • 17 Posts
  • 9 Reply Likes
I think Michael was referring to the 802.3at POE specifically.  As the original 802.3af standard will not provide enough power for it to function fully.  
Photo of Sathish Kumar KS

Sathish Kumar KS

  • 6 Posts
  • 0 Reply Likes
Thanks for pointing out Brian. I am not using at PoE. Could you please suggest me the best suitable 802.3at PoE for R730 available in market? we are looking for single port adapter.
Photo of Brian Powers

Brian Powers

  • 17 Posts
  • 9 Reply Likes
Sathish,

Sorry, was traveling late last week.  With POE being standardized, any power injector that states it supports the 802.3at standard should suffice.  I typically prefer to power APs w/switches though as in my environment, it is simpler.  So I do not have a good recommendation for a .3at power injector.  Sorry.
Photo of Sathish Kumar KS

Sathish Kumar KS

  • 6 Posts
  • 0 Reply Likes
Brian, i am observing same issue with Tenda TE-POE30G-AT Gigabit PoE Injector (White) also.

[ link removed by Administrator so post isn't seen as SPAM]  (Google it yourselves)  
(Edited)