How to add additional unleashed device ?

  • 1
  • Question
  • Updated 7 months ago
  • Answered
  • (Edited)
I have 2 R310 devices in office.
Both was working fine.

I upgrade both to 200.7.10.2.339.
Master was upgrade successfully but another one was fail.

I see slave device was disconnected in dashboard. OMG!

I upgraded slave R310 to 200.7.10.2.339 manually but still disconnected.
I removed it from dashboard then reset but still can't map the mesh network automatically.

It always in normal unleashed setting page.
How could I do?

Re-create mesh network?

I will add other one R310 into mesh network in few month.
I need re-create again at that time?





Photo of Mathew

Mathew

  • 3 Posts
  • 0 Reply Likes
  • sad

Posted 7 months ago

  • 1
Photo of Jeronimo

Jeronimo

  • 337 Posts
  • 40 Reply Likes
When AP do upgrading, Mater send URL to the AP to upgrade.

Thus the AP have to configure DNS IP.

First please confirm about it on another AP.


Photo of Mathew

Mathew

  • 3 Posts
  • 0 Reply Likes
I already done DNS setting when I done the unleashed setting 1 year ago.
I remote in dashboard by master device IP then use dashboard upgrade bottom to do upgrade.
After upgrade done, dashboard say slave device upgrade fail and disconnect.
Photo of Mathew

Mathew

  • 3 Posts
  • 0 Reply Likes
I reset all of three device to make them in a unleashed group.