How long should it take an AP to join up with a zone director? I can see it and it is approved but I can't edit, I need to change it's IP.

  • 1
  • Question
  • Updated 2 years ago
How long should it take an AP to join up with a zone director? I can see it and it is approved but I can't edit it as I need to change it's IP.
Photo of ET Venturer

ET Venturer

  • 2 Posts
  • 0 Reply Likes

Posted 2 years ago

  • 1
Photo of Monnat Systems

Monnat Systems, AlphaDog

  • 759 Posts
  • 162 Reply Likes
under 5 minutes if all is ok as per my experience.

if yo can see it and is approved but can't edit then it means that AP is not in "connected" state.

check the AP event and activities to see ZD-AP connection behaviour for clues..
Photo of Michael Brado

Michael Brado, Official Rep

  • 2101 Posts
  • 297 Reply Likes
If you can ping APs, try SSH and login with ZD admin credentials.
Do you see the ZD's IP when you type 'get director'?

Else try 'set director ip <zd_ip_address>', followed by 'reboot'.

This should send the AP's LWAPP request to the ZD on next boot up.

Follow your Monitor/Access Points page Events/Activities log like Monnat suggested to see if it connects, or...?