How do you show the arp table on a ICX 7450 running 08.0.30q ?

  • 1
  • Question
  • Updated 4 weeks ago
How do you show the arp table on a ICX 7450 running 08.0.30q ?
Our previous version: 07.3.00j that ran on the FCX 648 you could simply issue a "sh arp"  command.
Photo of Alvis

Alvis

  • 4 Posts
  • 0 Reply Likes

Posted 4 weeks ago

  • 1
Photo of Ben

Ben, Employee

  • 47 Posts
  • 8 Reply Likes
"show arp" in 8030 as well. 
Photo of Alvis

Alvis

  • 4 Posts
  • 0 Reply Likes
Ben, It doesn't show everything in the arp table when I do a "sh arp" in 8030q.
Photo of Ben

Ben, Employee

  • 47 Posts
  • 8 Reply Likes
Keep in mind those will only arps that we need to maintain. Are we the gateway for your hosts? Is this an L2 or L3 switch?
Photo of Alvis

Alvis

  • 4 Posts
  • 0 Reply Likes
L3
Photo of Ben

Ben, Employee

  • 47 Posts
  • 8 Reply Likes
Should be there then as long as we are resolving the arp for that host. If another switch is the gateway for the host, we won't (or don't need) to keep track of it. 
Photo of Alvis

Alvis

  • 4 Posts
  • 0 Reply Likes
Thank you
Photo of NETWizz

NETWizz

  • 26 Posts
  • 8 Reply Likes
You might need to do a ping sweep first.  Sh Arp works fine in 08.00.30Q.  I just checked
Photo of Scott Farrand

Scott Farrand

  • 9 Posts
  • 3 Reply Likes
Arp will not show anything if your management vlan isn't the client vlan.  If you're trying to hunt down a given device, it's a little more complicated, and you'd need to start from your routing switch/device.