FW versions between AP and ZD

  • 2
  • Question
  • Updated 4 years ago
  • Answered
Just updating our hugely out of date ZD1006 and the attached AP's, do the AP's have to be running the same FW versions or doe sit not matter which FW the two devices run, ie ZD on 9.3.4.0.17 and the AP's on 9.7.x?
Photo of Tristen Robinson

Tristen Robinson

  • 3 Posts
  • 0 Reply Likes

Posted 4 years ago

  • 2
Photo of Bill Burns

Bill Burns, AlphaDog

  • 203 Posts
  • 38 Reply Likes
AFAIK:
When an AP associates w/ a controller, it gets it's firmware from the controller.
When the firmware is updated on the controller, the APs go though a "double reboot" process.
After the first reboot, a new firmware version is downloaded to the AP.
After the second reboot, the AP is running the new firmware version.

This may result in a little more downtime than anticipated.
Photo of Primož Marinšek

Primož Marinšek, AlphaDog

  • 413 Posts
  • 48 Reply Likes
@Tristen The AP will get auto downgraded to 9.3.4 FW when it gets picked up by the ZD.
Photo of Keith - Pack Leader

Keith - Pack Leader

  • 860 Posts
  • 51 Reply Likes
And so a caution with the ZD1000 - it's unable to run anything newer. Some of our newer AP's (7982, 7055, 7352) require 9.4 or higher. So if you have a ZD1000 (which is EOL) you may not be able to use our newer access points at all. Luckily, many of our resellers offer trade-in programs that are pretty reasonable.
Photo of Tristen Robinson

Tristen Robinson

  • 3 Posts
  • 0 Reply Likes
Ok thats cool then, I'll upgrade the ZD which in turn, if required will update the AP's..

As for it being EOL, yeah I noticed that, kits been in for a while and since way before I started, need to reconfigure it though so figured perhaps a new FW might be in order just as a bit of house keeping, its well overspecced for what we need but I'm going to see if it'll do some stuff to help reconfigure the Wifi, I want 2 networks, one for normal internal access and one for guest/byod net access using its own IP range, guessing DHCP from the DC and vlans on the wifi rather than DC for one and ZD-DHCP for the other..
Should probably start a new thread for that though lol
Photo of Alec Gold

Alec Gold

  • 1 Post
  • 0 Reply Likes
hmmm good to read this as I was going to get a ZD1000 and link it to a few newer ZF's....
Is there a good trade-in programm in the Netherlands, Europe?
Photo of Tristen Robinson

Tristen Robinson

  • 3 Posts
  • 0 Reply Likes
Update ran last night, all good, both AP's and the ZD now on 9.3.4.0.17...

Now for the reconfiguring of Guest WiFi :)