Do P300/7311 Point to Point Bridges Need a Controller?

  • 1
  • Question
  • Updated 2 years ago
I have been tasked with finding a solution to connect two buildings with a point-to-point wireless bridge, and I came across these two devices. My question is, do they operate independent of the ZD, or is one required in the topology? I have found some drawings online that describe the topology for these devices that includes a ZD, but whether or not the ZD is required is unclear. There also is information pointing at the "ZoneFlex" product for managing these, but again, it is unclear from my reading how these devices need to be set up.

Any info is appreciated.
Photo of Jeremy Parra

Jeremy Parra

  • 3 Posts
  • 0 Reply Likes

Posted 2 years ago

  • 1
Photo of Dionis

Dionis, AlphaDog

  • 63 Posts
  • 34 Reply Likes

Not required...

Very easy setup process.  Very solid performance.


Photo of John D

John D, AlphaDog

  • 497 Posts
  • 136 Reply Likes
Not required, and even not supported for the P300. They're basically like invisible ethernet cords in the sky, and don't need any active management/configuration/administration after initial setup (described in the manual)
Photo of Jeronimo

Jeronimo

  • 115 Posts
  • 13 Reply Likes
Bridge Aps are only worked Standalone mode.
(Edited)
Photo of Paul Van der Cruyssen

Paul Van der Cruyssen

  • 9 Posts
  • 2 Reply Likes
Standalone mode or via Flexmaster
Photo of Monnat Systems

Monnat Systems, AlphaDog

  • 714 Posts
  • 151 Reply Likes
looking the URL below, there are "plans" to have P300 being managed by a controller/SZ too.

Source: P300 FAQ's - http://docdro.id/en9qwUj
(Edited)