Crashed Firmwire ZD1100

  • 1
  • Question
  • Updated 3 years ago
i'm facing a problem zd1100 firmwire crashed ... where can i download new firmware? and now display zd webportal in rescue mode ...
Please help me as soon as possible.
Photo of Saleem Sattar

Saleem Sattar

  • 2 Posts
  • 0 Reply Likes

Posted 3 years ago

  • 1
Photo of Max O'Driscoll

Max O'Driscoll, AlphaDog

  • 321 Posts
  • 77 Reply Likes
download for latest release is a link at bottom of release notes pdf.

Cannot advise how to install from command line/ssh with putty.

If you have recent backup config file (I hope) then could do a factory reset and start from that.
Basic configure back onto network to get ZD GUI.
Then go through whatever firmware steps you need to get to where you were then restore backup config. Long involved process, not difficult, just many steps and time consuming.

Better to wait for bigger minds than mine to advise.
The tech support staff are very good...worth opening a case and getting some help.
Photo of Michael Brado

Michael Brado, Official Rep

  • 1968 Posts
  • 275 Reply Likes
HI Anusha,
This is regarding ticket number 181361.
Issue has been resolved. I just restored new firmware and hard rebooted once again.

Regards,
Saleem Sattar
Photo of Saleem Sattar

Saleem Sattar

  • 2 Posts
  • 0 Reply Likes
I downloaded the firmware from premium user account .... and recovered the rescue mode message error "no storage connected" ....
Please see the article # 000001481
after completing this procedure try to hard reset again ....