Client Isolation override

  • 1
  • Question
  • Updated 3 years ago
  • Answered
Is there a way to override client isolation to make specific exceptions, say for a small group or a printer? Can you configure custom filters for MAC forwarding table?
Photo of William Fowler

William Fowler

  • 18 Posts
  • 0 Reply Likes

Posted 4 years ago

  • 1
Photo of Bittu

Bittu, Employee

  • 43 Posts
  • 13 Reply Likes
Official Response
Hello William,

If you have enabled Full Client Isolation on a WLAN, the Restricted Subnet (ACL) gets automatically applied on this WLAN and blocks access to all internal network devices, if you would like to allow access to certain devices like printer's you have to configure the Restricted Subnet available under Configure > Guest Access > Restricted Subnet. Here you will have to enter the IP address of the device you want user's to have access with a subnet of /32. For example if the IP address of the printer is 192.168.15.65, to give access you will have to enter 192.168.15.65/32 , this implies that all host bits need to match to allow access .

All the best.