Cisco VTP support over P300 wireless bridge?

  • 2
  • Question
  • Updated 1 year ago
  • Answered
Does anyone know if VTP is supported over the wireless bridge? I am new to Ruckus products and just purchased a pair of P300 radios to extend our network. The radios are connected to 2 Cisco switches which also provide PoE for the radios. The bridge is up and forwarding traffic to the far end switch using a dot1q trunk. However, I don't see VTP advertisements going across to the far end switch. Is VTP not supported? I can work around the problem by defining vlans locally on the switch but I would prefer to not have to do this.
Photo of eatons514

eatons514

  • 1 Post
  • 0 Reply Likes

Posted 2 years ago

  • 2
Photo of Samuel Acosta Jr

Samuel Acosta Jr

  • 2 Posts
  • 0 Reply Likes
I am looking for the same answer, i have 2 pairs of P300's now that this issue resides on.
Photo of Michael Brado

Michael Brado, Official Rep

  • 1982 Posts
  • 277 Reply Likes
Contact Ruckus Tech Support and request the patch for ER-3592: P300 ptp
backhaul not passing VTP between Cisco VLAN Trunk Protocol enabled
switches. (KBA-5872)
(Edited)