Can I use Passpoint with Samsung Galaxy S3 phones on ZoneDirector?

  • 1
  • Question
  • Updated 4 years ago
Can I use Passpoint with Samsung Galaxy S3 phones on ZoneDirector?
Association Response doesn't reply from ZoneDirector.

-------------
Interworking Element 107
Accessnetwork Type: WildCard
Internet : 0
ASRA : 0
ESR : 0
UESA : 0
-------------
Photo of POP Brian

POP Brian

  • 4 Posts
  • 0 Reply Likes

Posted 4 years ago

  • 1
Photo of Keith - Pack Leader

Keith - Pack Leader

  • 860 Posts
  • 50 Reply Likes
I've emailed you our technote on the subject. Based on some internal discussions, with the S3 it looks like there are carrier/country specific updates that may need to be applied. Best bet if you still can't get it working with the technote is to open a support case https://support.ruckuswireless.com/co....

This page might also be useful. http://mcclist.com/mobile-network-cod...
Photo of POP Brian

POP Brian

  • 4 Posts
  • 0 Reply Likes
Thank you so much!
I've get your Email! I'll check!
Photo of POP Brian

POP Brian

  • 4 Posts
  • 0 Reply Likes
I still have the problem. HESSID mismatch between APC and STA is occurred.

1.Set HESSID=03:00:00:00:00:00 to APC
-> Success
Assoc Req. with no Interworking HESSID. Interworking bit is exist.

2.Set HESSID=58:93:96:4e:7a:e8 to APC
->fail
No response to Assoc Req. from AP

AP deauthenticate STA.
HESSID mismatching is occurred, STA's Assoc Req is not include the HESSID infomation.

Also, I checked wpa_supplicant.conf of GS3.
There is no HESSID values.
Photo of POP Brian

POP Brian

  • 4 Posts
  • 0 Reply Likes
I also check Set HESSID to wpa_supplicant.conf of GS3.

Set HESSID=11:22:33:11:22:33 to APC and STA, then Fail.
Photo of Keith - Pack Leader

Keith - Pack Leader

  • 860 Posts
  • 50 Reply Likes
As I've mentioned in other threads - PassPoint configuration is very complex, and so attempting to diagnose these issues in a public forum is not recommended. Please open a support case as mentioned above.