AP's going into Mesh eMesh mode

  • 1
  • Question
  • Updated 4 years ago
I have 12 APs' and 7/12 are showing in mesh/emesh status.  I am unsure why this is happening.  I understand that they can go into mesh mode if the cable fails but I can't imagine that 7/12 of my cables have failed. Is there any other reason this could be happening?
Photo of Jeremy Reed

Jeremy Reed

  • 7 Posts
  • 0 Reply Likes

Posted 4 years ago

  • 1
Photo of Demetris Demetriou

Demetris Demetriou

  • 20 Posts
  • 3 Reply Likes
Are you sure that you don't have any single point of faillure among those 7 APs? Common Switch maybe?Are they on same floor/area? power faillure? I used to lose the APs of an entire floor of a hotel due to power faillure.