Applications data reporting on SCG 200 v3.4

  • 1
  • Question
  • Updated 3 months ago
Hello there,

Is application data reporting supported on SCG? Below is the current version of our SCG planes and our SCI version 3.6.0 - The application report is blank not sure if it is a configuration issue or a firmware version issue.. 
Controller Version 3.4.1.0.208
Control Plane Software Version 3.4.1.0.38
Data Plane Software Version 3.4.1.0.59

Kindly assist.
Regards,
Themba
Photo of Thembelani Ncube

Thembelani Ncube

  • 1 Post
  • 0 Reply Likes

Posted 3 months ago

  • 1
Photo of Monnat Systems

Monnat Systems, AlphaDog

  • 918 Posts
  • 191 Reply Likes
when you are referring to application data report, are you talking about  "Application Recognition and Control (ARC)"...??

I am using 3.6.0.0.510 Vsz, i can see this feature but no reporting in it
Photo of Lakshmi Nagarajan

Lakshmi Nagarajan

  • 23 Posts
  • 5 Reply Likes
Hi Themba, application data is supported in SZ 3.4.1. Please check if "Enable SCI reporting" is checked on the controller and the SCI details are provided there.

Also please ensure that port 1883 is open on SCI for incoming traffic.

Thanks
Lakshmi
Photo of Marcus Burton

Marcus Burton, Official Rep

  • 25 Posts
  • 14 Reply Likes
Also, application reporting is not supported in SCG200 in 3.4.1. It is first supported in 3.5.x releases (it is supported on SZ100/vSZ-E in 3.4) 

If your product supports app recognition, it must be enabled at the WLAN level. If you don't have it enabled there, then you will not find data in SCI.