AP R710 and R510, not respond ping command, and cannot connect to console

  • 1
  • Question
  • Updated 12 months ago
Hi , I have a problem with new equipment AP R710 and R510, these are connected to port of switch POE and to laptop y when turn on, viewing command respond ping command, but, do not are responding after two o four answers correct, then cannot connect to console for configure the AP, ¿canyou helpme?
Photo of Joel Aguirre

Joel Aguirre

  • 1 Post
  • 0 Reply Likes
  • confused

Posted 12 months ago

  • 1
Photo of Alexey

Alexey

  • 56 Posts
  • 11 Reply Likes
Check your network connectivity first. Turn on DHCP in the broadcast segment where the AP are on then reset APs to give them a possibility to get an IP address from your DHCP server.
Check ports status (speed&duplex) & ip conflicts in your network.
Photo of Pralhad Vishwakarma

Pralhad Vishwakarma, Employee

  • 1 Post
  • 0 Reply Likes
Hi Joel,

===>  Try to connect this AP in the place of a working AP and check if it is working fine.
===>  Remove the AP from the network and Power on using adapter / PoE switch. Perform a hard reset by pressing the hard reset button for 20 seconds (AP must be powered on).
===>  Try to connect the AP to the Laptop and ping the AP on the default IP 192.168.0.1 and make sure the laptop IP address is also in 192.168.0.x range.

If this does not help and still there are PING drops, please reach out us at below-mentioned numbers.


Pralhad S V
Technical Support Engineer
Phone: +1-855-782-5871 or +1 855-RUCKUS1
Join the conversation! https://forums.ruckuswireless.com
Ruckus Networks, an ARRIS Company



Photo of Jeronimo

Jeronimo

  • 337 Posts
  • 40 Reply Likes
We met same issue many many times.

You have to RMA at this issue.

You have no method to solve because Ruckus ap don't have console port.

Regards.