Any reason not to enable 802.11r/k

  • 1
  • Question
  • Updated 2 years ago
We have a lot of iOS clients on our wlans and I'm wanting to know if there is any reason NOT to enable 802.11r and k on these wlans? (we have ZD1100 running 9.9.1) Is there any downside or negative effect I'm not aware of? I'm always wary of settings that are defaulted to off... makes me wonder if there's a reason you wouldn't want to enable them.
Photo of Jim Michael

Jim Michael

  • 37 Posts
  • 11 Reply Likes

Posted 2 years ago

  • 1
Photo of Monnat Systems

Monnat Systems, AlphaDog

  • 714 Posts
  • 151 Reply Likes
Hi jim

802.11r/k is primarily for seamless roaming and if you WiFi network is working ok including roaming for all type of devices including ioS then its ok to have it off

however if i would be in your place then i would enable it as all devices do NOT support and those do support will have better and quick roaming experience.

apple device by the way support 802.11r/k so better to have it ON...

read - https://support.apple.com/en-in/HT202628

Hope this helps in making better decision...
(Edited)
Photo of Jacob Bennefield

Jacob Bennefield

  • 2 Posts
  • 0 Reply Likes
From personal experience we have a large ruckus deployment and 802.11r isn't ready for prime time.  We run a 802.1x network and with 802.11r IoS devices couldn't connect after the radius authentication hand shake.  When we turned off 802.11r the devices could connect again.  If your network is working fine then leave it off.
Photo of jbrown

jbrown

  • 4 Posts
  • 1 Reply Like
I am using the zero IT activation and have r/k enabled seems to work fine for most devices, however we have had a few 7-8 year old laptops that will not connect once the r/k was turned on. We where having issues with devices moving from AP to AP when mobile, with turning on the r/k that has improved that issue. 
Photo of John D

John D, AlphaDog

  • 497 Posts
  • 136 Reply Likes
Certain extremely old pieces of hardware (especially 802.11b/g devices) refuse to connect or even recognize networks that have 802.11r enabled. I got burned by this after digging up some PC relics to salvage some data off of them.

But they are few and far in between. If you are concerned about this, you may want to make a separate "legacy" SSID for such devices.
Photo of Austin Wahl

Austin Wahl

  • 5 Posts
  • 0 Reply Likes
just clone the wlan and have the same ssid, havent had any issues when doing this.    some olderish macbooks wont connect with it on, almost every device 2 years or newer will support 11k/r.