As always, please refer to the Release Notes for details regarding this
release, supported APs, ZD upgrade path, new features, etc.
I would agree except for this:
"Officially Supported 9.10 Upgrade Paths
The following ZoneDirector builds can be directly upgraded to ZoneDirector build
• 184.108.40.206.212 (9.9 GA)
• 220.127.116.11.212 (9.9 GA refresh)
• 18.104.22.168.216 (9.9 GA refresh)
NOTE: If you do not have a valid Support Entitlement, you will be unable to upgrade
ZoneDirector to this release. See Administer > Support page for information on
Support Entitlement activation.
Due to the enforcement of the Support Entitlement feature in ZoneDirector 9.10,
Ruckus recommends upgrading to 9.10 from one of the above 9.9 builds only.
You can also upgrade directly to 9.10 from one of the following 9.8 builds. However,
you will be prompted to reset to factory defaults before the upgrade can continue.
(This is not required when upgrading from 9.9 to 9.10.)
9.8 builds that can be directly upgraded to 9.10 (requires factory default):
• 22.214.171.124.379 (9.8 GA)
• 126.96.36.199.101 (9.8 Maintenance Release 1)
• 188.8.131.52.15 (9.8 Maintenance Release 2)
If you are running an earlier version, you must first upgrade to one of the above
builds before upgrading to this release."
You basically have to go to 9.9 before 9.10 unless you want to reset config. This doesn't mention if you can do a restore, which I hope you can?
While it could be be something else going on but wanted to put this out there and see if others have experienced this issue or any other problems?
For what it's worth, I have two ZD1125's in a Smart Redundancy pair with a ZF700 & a ZF7982.
ZD1125 with 22 APs mixed 7362 and R500.
No issues reported with my numerous iPAD users.
Neither confirms or denies...just my situation.
Would suggest you raise a case with support or start a new thread with more specifics.