802.11w PMF , set as Required , R510 - Unleashed

  • 1
  • Question
  • Updated 5 months ago
  • Answered
  • (Edited)
Hi

How do I ( using unleashed GUI or CLI )
make 802.11w Protected Management Frames
*Required* on an R510 AP.

Thanks
Andy
Photo of Andrew Romero

Andrew Romero

  • 2 Posts
  • 0 Reply Likes
  • confused

Posted 5 months ago

  • 1
Photo of Sanjay Kumar

Sanjay Kumar, Employee

  • 170 Posts
  • 67 Reply Likes
Hi Andrew,

This option is not available on the GUI. From the CLI, enter the command "80211w-pmf 2" from the WLAN prompt.

Below is the example.

ruckus> en
ruckus# conf
You have all rights in this mode.
ruckus(config)# wlan test
The WLAN service 'test' has been loaded. To save the WLAN service, type 'end' or 'exit'.
ruckus(config-wlan)# 80211w-pmf
<NUMBER> Enter the number,0:Disable,1:Optional,2:Required..
ruckus(config-wlan)# 80211w-pmf 2
The command was executed successfully. To save the changes, type 'end' or 'exit'.
ruckus(config-wlan)# end
The WLAN service 'test' has been updated and saved.
Your changes have been saved.
ruckus(config)# end
Your changes have been saved.
Photo of Andrew Romero

Andrew Romero

  • 2 Posts
  • 0 Reply Likes
Sanjay, Thanks !!