Conversations

Photo of Pamuditha Abeysekara
Creating 2- Node SCI Setup ( Master Node + Data Node)
Hi,  I have few questions about 2-Node SCI setup where we have more than 3000 APs. 1.) Do both SCI nodes (master and data) have web GUI?...
  • 1 me too
  • 3 replies
  • Question
Photo of Pamuditha Abeysekara
How to Protect SCI Database?
Hi all, Is there any redundancy mechanism or HA mechanism supported by SCI. Since it contains sensitive data what can we adhere to as a...
  • 1 me too
  • 5 replies
  • Question
Photo of Pamuditha Abeysekara
Are Ruckus Products OpenStack Ready?
Hi, Since cloud and NFV platforms are emerging, I would like to know whether VSZ, SCI and vSPoT have been tested or ready to be deploye...
  • Pamuditha Abeysekara, 2 weeks ago

  • 1 me too
  • 0 replies
  • Question
Photo of Pamuditha Abeysekara
AP Alarm and Event Management per AP Group
Hi, Is it possible to create MVNO to view and control only a specific AP group instead of AP zone? Next question is, is it possible t...
  • 1 me too
  • 1 reply
  • Question
  • Acknowledged
Photo of Pamuditha Abeysekara
vSZ Version Downgrade
Hi Is it possible to downgrade vSZ 3.4 to 3.2 ? Is it similar procedure as upgrading vSZ?
  • 1 me too
  • 4 replies
  • Question
Photo of Informatica SATC
Extend disk VSZ
Good morning, I'm trying to extend my disk VSZ-E and I'm not getting. I tried qemu-img NAME +size, but the command is not accepted. I'm c...
  • 1 me too
  • 3 replies
  • Question
Photo of Pamuditha Abeysekara
VirtIO vs IDE for vSZ VM
Is there any recommendation between these two for vSZ? What if other one used? Any known issues? Also what is the impact of using both...
  • Pamuditha Abeysekara, 4 months ago

  • 1 me too
  • 0 replies
  • Question
Photo of Pamuditha Abeysekara
Encountering Issues on SCI GUI
Hi, I have installed SCI 2.4. It is showing errors no data available/data cannot be retrieved etc in some PCs and browsers. In same mac...
  • 1 me too
  • 6 replies
  • Question
Photo of Pamuditha Abeysekara
vSZ cluster nodes with different resources
Is it possible to run 2 vSZ cluster with each node having different set of resource values in two host servers. Say 1 node with RAM,vCP...
  • Pamuditha Abeysekara, 4 months ago

  • 1 me too
  • 0 replies
  • Question
Photo of Pamuditha Abeysekara
SCI v2.4 Application level stats
Application level stats of clients is not visible in SCI 2.4. VSZ 3.4.1 is used. AP R500 T300. Fo I have to configure anything on A...
  • 1 me too
  • 9 replies
  • Question
Photo of Pamuditha Abeysekara
Can I create 2-node vSZ cluster setup with each node having different VLANs.
I am creating 2 node vSZ cluster. Nodes will be put in two different sites. As per network architecture, VLANs are not span between sites...
  • 2 me toos
  • 8 replies
  • Question
  • Answered
Photo of Pamuditha Abeysekara
Portal Redirection for WISPr Portal not happening
Client connected to Hotspot authentication based SSID and gets IP from DHCP pool. Redirection to portal page is not happening. IP pool ...
  • 1 me too
  • 3 replies
  • Question
Photo of Pamuditha Abeysekara
SoftGRE configuration help
Hi all, Can any one provide softgre tunnel config setup on both vSZ and WaG side. I am using cisco ASR1400 as WAG. Any FW ports to be...
  • Pamuditha Abeysekara, 5 months ago

  • 1 me too
  • 0 replies
  • Question
Photo of Pamuditha Abeysekara
Using AP to Captive portal redirection with SoftGRE
Hi all, How to use captive portal redirection from the AP while having data tunneled to Cisco ASR1400 with SoftGRE? In the vSZ configur...
  • 1 me too
  • 2 replies
  • Question
  • Answered
Photo of Pamuditha Abeysekara
Can I use SoftGRE tunnel for set of SSIDs while using local breakout for other SSIDs in the same AP
vSZ managed R500 AP will have 4 SSIDs. 3 SSIDs will use portal authentication and softGRE tunnel to Cisco iWAG as data path. 1 SSID will ...
  • 1 me too
  • 1 reply
  • Question
  • Answered
Photo of Pamuditha Abeysekara
SCI 2.4 installation on KVM
Hi, I am installing SCI 2.4 as single node setup (master ) in KVM with CentOS 7.3. Is it possible to follow installation guide becaus...
  • 1 me too
  • 3 replies
  • Question