Conversations

Photo of Jeronimo
A poor throughput performance standalone AP with NAT forwarding.
I have tested throughput test with NAT forwarding for Ruckus AP and some vender APs.On Nat-forwarding, Aruba(IAP mode)and Samsung AP(stan...
  • 1 me too
  • 3 replies
  • Question
  • Acknowledged
Photo of Ali Sureyya Uz
Is it possible to controll all AP's after a wireless bridge with zonedirector?
Is it possible to control all Ruckus AP'S after a bridge with the all feaure of Zone director? Here is the configuration
  • 1 me too
  • 4 replies
  • Question
  • Answered
Photo of Jeronimo
not working SCI v5.1.1 after a setting which dhcp ip to static ip
Hi.I tried to deploy latest SCI v5.1.1 for DEMO.I notice that after I completed initial seup complete with dhcp ip, if I re-configured dh...
  • 1 me too
  • 1 reply
  • Question
  • Answered
Photo of Michael Hypolite
Using a T710 with P300 connected to PoE out for back-haul
I need to provide Wifi To areas with no wired network infrastructure, mounting locations will be on the light pole. I was wondering if th...
  • 1 me too
  • 1 reply
  • Question
  • Answered
Photo of Bryan Medina Alzamora
Too much delay when I enter to the SZ100 dashboard
When I try to enter the SZ100 throught web browser it takes too much time to load, around 2 minutes in every step, this only happens on w...
  • 1 me too
  • 3 replies
  • Question
Photo of Nnamjin Roh
What is " snapshot disk" command in VSCG for?
I found "snapshot disk" command in VSCG.  How can I use this command"  what is this command for?
  • 1 me too
  • 3 replies
  • Question
  • Answered