Conversations

Conversations 1 - 20 of 279
Photo of mark lee
Get CLI config files of ZD ,like cisco's show run
I want to use a cli like cisco's 'show run' to get the cli configuration. And then enter this configuration to a new deivce by CLI. I ...
  • 1 me too
  • 3 replies
  • Question
  • Answered
Photo of moncef zellou
System ZD 1100 USB
Hello I format the USB key which is located at the inner casing of ZD 1100 helped me how can I repair my zone director
  • 1 me too
  • 4 replies
  • Question
  • Answered
Photo of Jelle Alten
PHY Errors, Noise Floor, Airtime interpretation in ZD
I would like to find out what values for PHY Errors, Noice Floor, Airtime total, busy, RX, TX are good and what values are bad? If I'm...
  • 4 me toos
  • 8 replies
  • Question
Photo of Marco Eichstetter
Security of a Wireless Guest Network
Hi,i have a security question reagarding a Ruckus Guest Network.Basicly the Guest Network is not encrypted (by Default). No WPA2. But the...
  • 2 me toos
  • 8 replies
  • Question
Photo of Bar Chiu
Standalone R700 AP with DHCP issue
Hi everyone, I'm done configuring an R700 AP as a standalone AP but I always get a different address - 169.254.27.89 with subnet mask of...
  • 1 me too
  • 4 replies
  • Question
  • Answered
Photo of John D
R710: "PoE+" injector still gets recognized as 802.3af power
For fun, I tried buying a PoE+ injector to unlock full transmit power on 2.4GHz on my R710. I found that even with an injector that's adv...
  • 1 me too
  • 4 replies
  • Question
  • Answered
Photo of Vic Lazzarevich
Looking for a WiFi to Ethernet bridge.
I have a device far from an IDF that needs an IP. Looking for a WiFi to Ethernet bridge. Can I connect a 7372 AP to a wired 7762 via me...
  • 1 me too
  • 7 replies
  • Question
Photo of Robert Wrenn
P300 SpeedFlex test , is it accurate?
Using a P300 bridge about a quarter of a mile apart to connect a ZoneDirector 1106 to six 7782 APs. We were expecting at least 500Mbps u...
  • 1 me too
  • 6 replies
  • Question
Photo of WIFi GUY
Wireless Ethernet Bridge (NETGEAR WNCE2001)
I have a customer that I provided an unleashed solution to. It was a simple install, and has worked flawlessly. Finally a price point tha...
  • 1 me too
  • 3 replies
  • Question
Photo of Jeff W
Unleashed AP approval issues with 200.2.9.13.186
With previous firmware versions I could enable/disable automatic approvals.  I just updated to 200.2.9.13.186 and it seems the approval o...
  • 2 me toos
  • 6 replies
  • Question
  • Answered
Photo of Jason Pearcy
R600 Factory Reset Button
Trying to reset an R600 with the reset button and not having luck. With previous APs holding the reset button in for a period of time res...
  • 2 me toos
  • 6 replies
  • Question
Photo of xisco lladó
Accessing wifi with facebook login
I have a captive portal with a facebook share option. I want users that share have granted access to our wifi trough zonedirector. It ́s ...
  • 1 me too
  • 2 replies
  • Question
Photo of John D
What are "Smart Roaming QoS classification CLI commands" in the latest Unleashed?
I saw in the Unleashed 200.5 GA Refresh 3 release notes: "Smart Roaming" QoS classi cat...
  • John D, 10 months ago

  • 2 me toos
  • 0 replies
  • Question
Photo of Jeff Roback
all support now offshore?
Does anyone know if all ruckus support has gone to a 100% offshore model?   I'm used to this with consumer products, but none of the othe...
  • 2 me toos
  • 1 reply
  • Question
Photo of William Burnett
Unleashed - Per Radio SSIDs
So I ordered a few R600 UNLEASHED APs for a client site that is having tremendous interference issues (4 story building with multiple ten...
  • 3 me toos
  • 7 replies
  • Question
Photo of tjeee tje
Sonos Play 5
I have 2 R500 Unleashed AP, the Sonos Play 5 stops playing after a few minutes. How can I fix this? I have look in the settings, but can...
  • 2 me toos
  • 2 replies
  • Question
Photo of Alexander Hartmann
question on malicious networks
Hello Ruckus fans. We are running a network with 260+ APs in hospitality. Nearby are several other hotels and an airport. The ZD shows s...
  • 1 me too
  • 2 replies
  • Question
Photo of JasonD
OSX Clients Connected to AP, but not passing traffic
Anyone else experiencing issues with OSX clients connecting to APs, then randomly not being able to pass traffic/browse the internet? We...
  • 7 me toos
  • 32 replies
  • Question
Photo of Jason Pearcy
Unleashed Band Balancing tuning
I have two Unleashed R600's and all of my devices but two cameras have 5ghz radios in them but 90% of my devices are connecting to the 2....
  • 1 me too
  • 5 replies
  • Question
Photo of MJ
R600 Unleashed - Functionality Differences?
Hi All - New to the Ruckus brand entirely and am curious what functionality (if any) will be lost using a controller less platform such ...
  • 1 me too
  • 6 replies
  • Question
  • Answered