How to have wireless clients on another subnet but access main lan gateway
Hi, Is it possible to have wireless clients get a different IP address range to our main LAN but still use the gateway on our main LAN. ...
Eizens Putnins
Joined on August 24, 2013
53
Likes received
0
Conversations posted
126
Replies posted
94
Conversations followed
Conversations
Conversations 1 - 20 of 93
How many entries can I add to ACLs on SZ100?
I have a project where customer says that he needs: 1. MAC authorization in WLAN; 2. ACL entries number should be more that 8k. I can't ...
MAC address authentication on Ruckus Smartzone-E 3.6
I am looking a solution as MAC address authentication on Ruckus Smartzone-E 3.6 with Radius server. Is it possible Version 3.6? Regard...
AP for elevator solution with IP camera
Hi, I am looking for solution to purpose for elevator IP cctv solution. Initially I purpose using T310n located on top of the building ...
Can I use Let's Encrypt service for providing SSL certificates for my ZoneDirector?
Has any one managed to use the free SSL provided Let's Encrypt to provide an SSL certificate for their ZoneDirector? Thanks
Converting an R500 AP to Unleashed R500
I see posts that are 2 years old on this topic - so I am looking for affirmation that this is a pretty straight forward push of the unlea...
ZD to vSZ Migration
Hi, I have two controllers. One of them is ZD
1200 and another one is vSZ configured as an Essentials with one interface (the
location ...
Any reason not to enable 802.11r/k
We have a lot of iOS clients on our wlans and I'm wanting to know if there is any reason NOT to enable 802.11r and k on these wlans? (we ...
Ruckus r510 connectivity with RF guns
Hi - we have around 25 r510 Ruckus installed at our warehouse in Fiji and controlled by ZD. in the warehouse we use RF guns ( cipherlab ...
2 x Ruckus R600 for USD$315. Good deal for new house build?
We are currently building a new home that is single storey and around 3000sqft. I was looking into Ubiquiti Nano HD but I am able to get ...
This Access Point is not approved/joined yet. Please connect it to proceed configuration.
Hello. I am using the ZoneDirector 3025, and I try to configure the access points but whenever i click on "Edit" this message appears " ...
Speed Throttling
Recently purchased two R510 for my home connected through a gigabit switch to a router. Cat6 wiring all around. Connection speed is 200mb...
Guest access portal asking for guest pass every time
We have implemented Guest Access at a client end,Client's IT team generates the Guest pass and assigns it to their guests.The guests here...
AP firmware 3.6.0.0.709 High Connection Errors
I have upgraded my Vsz to 3.6.0.0.510 and upgraded the APs to 3.6.0.0.709. After the upgrade i noticed that almost every AP had a high p...
Security of a Wireless Guest Network
Hi,i have a security question reagarding a Ruckus Guest Network.Basicly the Guest Network is not encrypted (by Default). No WPA2. But the...
I ordered 801-1205-5000 watchdog contract from a reseller, now what?
Hello, roughly 24hrs ago I ordered a 801-1205-5000 5yrs watchdog support for my ZD1205 because I want to have software upgrades for my ZD...
Ruckus ZD + Radius not working
Hi all, I'm trying to set up an wifi connection to our corporative notebooks with Active Directory + Radius auth. I've been folowing this...
I found how to configure AAA proxy-mode for 802.1x in vSZ-H.
Hi everyone. I have found this setting to AAA-proxy for 802.1x in vSZ-H. I finally found it. I have attached a snapshot for this sett...
T300 & T310 antenna gain and TX sensitivity
Hello, I would just like to know what is the relation between the antenna gain of an AP and Beamflex+. From information I have gathered f...
New to Ruckus. WLAN configuration help required.
Dear community, I am tasked to implement a new WiFi setup in our existing LAN. Our LAN computers are getting their IP addresses from th...