como hacer que se repita la misma red de un ruckus a otro ruckus?
tenemos un ruckus principal SERIE H510 en uno de los departamentos pero queremos poner otro ruckus en otro departamento, o como lo conect...
Conversations
Conversations 1 - 15 of 486
I cannot pair 2 ZoneFlex P300 Wireless Bridge,
I cannot pair 2 ZoneFlex P300 Wireless Bridge, have completed all the config but the wireless status on the non-root bridge says the wire...
bad firmware header magic
I am trying to upgrade my T300 outdoor AP with the OutdoorAP-100... firmware but I keep getting the "bad firmware header magic" error mes...
SNMP / Link status
Hello,it is possible via snmp to query the link status of the wireless connection?
P300 / Link status down
Hello,
our pair consisting of two P300s (firmware: 100.1.0.9.62) does not establish a link via wireless LAN.
The following entry app...
2.4Ghz Latency goes high suddenly
Hi all,I have an total ruckus environment ( ZD100 + Ruckus 610 APs) into 2 of my offices.On both offices, i have a problem on the 2.4ghz ...
Report on under performing AP's over a custom time period
Hi, we make use of a Virtual Smartzone. Is there a way to pull a report which indicates AP's that are under performing (AP's that are no...
How to Re-flash an Unleashed AP back to standalone or ZD firmware
Hi. I flashed a T300 to use the Unleashed firmware and now I would to convert this back to the original firmware but cant see an option ...
Ruckus AP mDNS Query "_communicator._tcp.local"?
While doing some packet analysis to define all the required ACL rules for Ruckus APs, I came across this curious query a new AP out of th...
Ruckus 7762s - Yellow/Red status LEDs, won't boot
I have a large outdoor network that still includes many Ruckus 7762 APs. Over the years I've accumulated a number of the 7762s that won't...
Move from zd500 to Smart zone 100
I have an working enviroment with 400 ap with zd5000 recundant and I need to migrate to zf100.
Do I need to put factory all ap? With i...
Increase AP in gateway mode performance (disable qos maybe?)
Does anyone have any ideas to improve performance on standalone APs in gateway mode?I have seen the KBs that state you should not expect ...
buenas tardes alguien sabe como configurar el H510 Series para agregar por filtrado Mac?
Quiero configurar el AP H510 Series por medio de filtro Mac pero no se como se hace
A poor throughput performance standalone AP with NAT forwarding.
I have tested throughput test with NAT forwarding for Ruckus AP and some vender APs.On Nat-forwarding, Aruba(IAP mode)and Samsung AP(stan...
Virtual smart zone - AP not advertising wireless
AP t310d no light on Air, 2.4 G and 5 G.the problem started after performing factory reset on the AP. The AP is on the proper WLAN group ...
ZoneFlex outdoor access points uniquely combine adaptive antenna technology and adaptive meshing to enable a new level of outdoor performance at a low cost.
